PAR Weathercoat
KANSAI PAINT | Building Products, Paints |
PAR Weathercoat is 100% Acrylic Exterior Wall Emulsion with 6 years protection warranty. Excellent fungal and algae resistance, 100% acrylic exterior paint that outlast ordinary emulsion. |
New, unpainted surfaces
Allow surfaces to cure and dry out at least 28 days. Large cracks must be repaired with cement: sand mix and rendered smooth. Make good all minor defects with appropriate exterior grade fillers. Remove all loosely adhering residues by thorough brushing.
Repainting
Check for fungus and algae growth. If present, treat the surfaces with fungicidal wash by brushing onto the surface with bleach mix (1 part household bleach with 3 parts water). Allow the mixture to penetrate the affected surface. Make good all defects with appropriate patching materials. When dry, remove all fungi, algae, chalk, loosely adhering contaminants by using high-pressure water-jetting. Check for powders if present, the surface must be sealed with a coat of Par Plasterseal 1001 Solvent based wall sealer.
New, unpainted surfaces
Repainting
NB: Par Primer Sealer 1035 and Par Plasterseal 1001 work best on surfaces with a moisture content of below 15% and alkalinity below pH-9, otherwise premature paint failure may occur.
Designed Use
For use on new or previously painted exterior masonry surface such as brickwork, plaster, cement rendering and asbestos where performance of up to 6 years protection is required.
Binder Type
Premium grade 100% pure acrylic binder pigmented with chalk resistant titanium dioxide and other high grade pigments that resist salts in new mortar, cement rendering and other surfaces.
Performance
- 6 Years Performance Warranty
- 100% acrylic resins-outlast ordinary emulsion
- Excellent fungal and algae growth resistance
- Excellent colour retention
- Tough synthetic finish – washable
- No added lead or mercury
Physical Properties
| Coverage* | 10-12 m²/Lit @ 25 microns |
| Volume Solids | White 40%, other colours will vary |
| Dry Film Thickness | 25 microns/coat |
| Wet Film Thickness | 63 microns/coat |
| Flash Point | Not applicable |
Finishing
| Finish | Smooth sheen finish |
| Pack Size | 5 & 20 litres |
Application
| Drying Times | Surface dry: 10 min; Recoat: 1-2 hours |
| Dilution | Clean household water |
| Cleaning Up | Clean household water |
Dilution Ratio
| Brush or Roller | Ready for use. If dilution is required, add up to 5% clean water |
| Conventional Spray | Dilution of up to 10% water |
| Airless Spray | Ready for use |
Spray Equipment Guide
| Conventional Spray | A typical set up would be a minimum atomising pressure of 2.8kg/cm² and fluid pressure of 0.4kg/cm³ with a nozzle size of 0.43mm |
| Airless Spray | A typical set up would be a minimum of 155kg/cm³ with a nozzle size of 0.38-0.43mm and a spray tip angle of 65° |
