PAR Supermatt
KANSAI PAINT | Building Products, Paints |
Rich Matt interior Wall Emulsion Brilliant and rich matt finish, soft touch, high-grade interior emulsion. |
New, unpainted surfaces
Allow surfaces to cure and dry out at least 28 days. Large cracks must be repaired with cement: sand mix and rendered smooth. Make good all minor defects with appropriate fillers. Remove all loosely adhering residues by thorough brushing.
Repainting
Check for powders or chalk. These surface contaminants must be completely removed by washing with warm water and detergent solutions. Rinse with clean water, taking care to change the rinsing water regularly. If after thorough preparation the surface is still slightly powdery it may be necessary to seal it with Par Plasterseal 1001 Solvent Based Wall Sealer. Dilute the sealer up to 30% and apply liberally to allow the sealer to fully penetrate the surface and form a barrier that seals up the chalk.
New, unpainted surfaces
Repainting
NB: Par Primer Sealer 1035 and Par Plasterseal 1001 work best on surfaces with a moisture content of below 15% and alkalinity below pH-9, otherwise premature paint failure may occur.
Designed Use
For use on new or previously painted interior masonry surfaces such as brickwork, plaster, cement rendering and asbestos cement where a rich matt finish is required. For exterior, use Par Weathercoat which offers a 6 years performance warranty.
Binder Type
Premium grade acrylic binder pigmented with chalk resistant titanium dioxide and other high grade pigments.
Performance
- Soft touch
- Brilliant and rich matt finish
- Anti-bacterial protection
- Excellent colour retention
- No added lead or mercury
Physical Properties
| Coverage* | 10-12 m²/Lit @ 25 microns |
| Volume Solids | 35% |
| Dry Film Thickness | 25 microns/coat |
| Wet Film Thickness | 76 microns/coat |
| Flash Point | Not applicable |
Finishing
| Finish | Rich matt finish |
| Pack Size | 1, 5 & 20 litres |
Application
| Drying Times | Surface dry: 10 min; Recoat: 1-2 hours |
| Dilution | Clean household water |
| Cleaning Up | Clean household water |
Dilution Ratio
| Brush or Roller | Ready for use. If dilution is required, add up to 5% clean water |
| Conventional Spray | Dilution of up to 10% water |
| Airless Spray | Ready for use |
Spray Equipment Guide
| Conventional Spray | A typical set up would be a minimum atomising pressure of 2.8kg/cm² and fluid pressure of 0.4kg/cm³ with a nozzle size of 0.43mm |
| Airless Spray | A typical set up would be a minimum of 155kg/cm³ with a nozzle size of 0.38-0.43mm and a spray tip angle of 65° |
